Intended use
3
Intended use
Magic Watch is an ultrasonic parking aid. It monitors space when manoeu-
vring.
MWE9008: in front of and behind the vehicle
MWE9004: behind the vehicle
It provides an audible warning signal for any obstacles it detects.
Magic Watch is designed for installation in cars and caravans.
4
Instructions before installation
4.1
Determining the place of installation for the
sensors
See fig. 3 to fig. 6
I
NOTE
The sensors must be correctly aligned for the device to work prop-
erly.
If these point to the ground, irregularities and bumps on the sur-
face may be interpreted as obstacles. If they point too far up,
obstacles will not be detected at all.
Note the following during installation:
The distance from the sensors to the ground should be between 40 cm
and a maximum of 60 cm (fig. 3).
For the sensors to function optimally, the angle of the sensor to the road
surface should be 90° (fig. 3). The angle may not be less than 90°, as
the road will otherwise be interpreted by the sensor as an obstacle.
The sensor holders included are suitable for all standard bumpers. Should
the vehicle bumper be mounted at a steep angle, 20° sensor holders with
a cover ring are available as an optional extra (see chapter "Accessories"
on page 21).
The sensor holders included are not suitable for installation in metal
bumpers. If your vehicle has metal bumpers, you will need special sensor
holders with a silicon ring (see chapter "Accessories" on page 21).
22
MagicWatch MWE9004, 9008
EN