Putting Into Operation; Switching Off - Makita HG5012 Bedienungsanleitung

Putting into Operation

Observe the mains voltage: The voltage of the power source must agree with the value given on the name-
plate of the unit. Extension cords must have a conductor cross section of 2 x 1.5 mm
Switching On:
: Set the switch 1 to I or II.
A
: Set the switch 1 to I or II. Set the temperature
B
controller 2 as required.
: Set the switch 1 to I. Select the desired pro-
C
gram or program the temperature and air flow
as required (see "Settings").
C Adjusting the Settings on the Display 2
Begin the selection with the SELECT pushbutton (menu). Note: When an indication flashes in the display, a
change can be initiated with either PLUS or MINUS. Repeated actuation of SELECT leads to the next step.
Language selection, temperatur
2 sec
ENGLISH
Selecting the function program
1 x
1-FREE
1. 1-Free setting
2. 2-Free setting
3. Shrinking
4. Forming
5. Soldering copper
6. Drying paint
7. Paint stripping
The keyword of the selected function program is indicated by flashing. Longer text begins to move after 2 sec-
onds and returns to the keyword after 2 passes. Within this period, the SELECT pushbutton can be pressed
again to adjust the temperature or the air flow.
Selecting STANDBY or COOL DOWN
COOL DOWN
– Select STANDBY when interrupting your work for short time. The energy absorption is reduced.
– At the end of your work, always select COOL DOWN. When the unit has cooled off, switch it off and pull
the plug from the receptacle.
PORTUGUES
1 x
WELDING
1 x
80 °C/5
80 °C/5
450 °C/5
500 °C/4
650 °C/3
650 °C/5
425 °C/5
English - 9 -

Switching Off:

Set the switch 1 to 0.
To cool the unit off, set the switch 1 to II and the tem-
perature controller 2 to MIN. When the unit has
cooled off, set the switch 1 to 0.
To cool off the unit, have it operate on COOL
DOWN (see "Settings").
When the unit has cooled off, set the switch 1 to 0.
FAHRENHEIT
1 x
CELSIUS
1 x
8. Welding PPEPDM
9. Welding HD-PE
10. Welding PP
11. Welding PVC-U
12. Welding ABS
13. Welding PC
14. Welding floor-foil
STAND-BY
2
min.
RESET
1 x
SAVE
280 °C/5
300 °C/3
320 °C/3
340 °C/3
360 °C/3
370 °C/3
450 °C/3