Operation; Maintenance - Makita BJS130 Bedienungsanleitung

OPERATION

Fig.9
Fig.10
CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece surface.
Adjusting shear blade
Fig.11
Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold the
cutting head. Move the side blade L back and forth to
adjust it. Then tighten the three screws with the hex
wrench.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Lubrication
Fig.12
Before operation, lubricate the contact point of the center
blade and the side blades R/L. And, also lubricate the
point of the center blade near the cutting head. To keep
good cutting performance, use lubricant from time to time
during operation.
Replacing carbon brushes
Fig.13
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First remove the holder by unscrewing the hex socket
head bolt.
Fig.14
Then loosen the hex socket head bolt that fastens the
barrel and turn the barrel counterclockwise.
Fig.15
Use a screwdriver to remove two screws then remove
the front cover.
Fig.16
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
Fig.17
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the
new ones and replace the carbon brush caps in reverse.
Fig.18
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
Fig.19
Reinstall the front cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Center blade
•
Side blade R
•
Side blade L
•
Hex wrench
•
Various type of Makita genuine batteries and
•
chargers
Shear head 16 set
•
7
or attachments
Only use accessory or
are