Minimum/Maximum Mode - Renkforce 2203406 Bedienungsanleitung

• To switch the alarm (or the alarm time) on or off, push the "SET" (5) button with the currently selected alarm.
When the alarm is activated, a bell icon " " is displayed at the lower right.
To leave the setting mode in any place, briefly push the button "HISTORY" (7). The settings made are
saved.
Alternatively, wait for 30 seconds without pushing a button. Setting mode is ended automatically in this
case.
• When an alarm is triggered (exceeding of a threshold at "HIGH ALARM", undercutting of a threshold at "LOW
ALARM" or at the alarm time), the base station will emit a sound signal and the bell icon " " flashes. The cor-
responding text message appears at the bottom of the display.
• Push any button to end the sound signal. If the measured value remains above or below the set threshold, the bell
icon " " will continue to flash, however.
e) Minimum/Maximum mode
In this mode, you can have the saved minimum and maximum values displayed.
• The base station must be in normal mode. Now briefly push the "MIN/MAX" (8) button to start the minimum/maxi-
mum alarm.
• The two lower text lines show "TODAY MAX".
To leave the minimum/maximum mode in any place, briefly push the button "HISTORY" (7).
Alternatively, wait for 30 seconds without pushing a button. Minimum/maximum mode is ended automati-
cally in this case.
• Briefly push the button "MIN/MAX" (8) repeatedly to switch between the following 4 functions:
"TODAY MAX"
"HISTORY MAX"
"TODAY MIN"
"HISTORY MIN"
" (3) or "
• Use the "
maximum value.
• Every minimum/maximum value can be deleted/reset by keeping the "SET" button pushed for 2 seconds.
68
Maximum values of the current day
Maximum values since the last reset
Minimum values of the current day
Minimum values since the last reset
" (4) button to call the time and date of occurrence in sequence for every minimum or