Moon Phase Display; Display Of Absolute And Relative Barometric Pressure; Setting The Relative Barometric Pressure - Renkforce 2203406 Bedienungsanleitung

h) Moon phase display
The lower right of the display shows the current moon phase graphically, depending on date. The display depends on
the settings for the northern/southern hemisphere of the Earth (see
tion "NORTH/SOUTH").
New moon
i) Display of absolute and relative barometric pressure
• The base station must be in normal mode.
• Use the " " (3) or "
so that the display range is marked with the arrow symbol "
• Briefly push the "SET" (5) button. The display will switch between the relative barometric pressure (display "REL")
and absolute barometric pressure (display "ABS").
j) Setting the Relative Barometric Pressure
The barometric pressure measured by the base station is the actual barometric pressure (= absolute barometric
pressure) at the site of setup of the base station. Since the barometric pressure will drop with increasing altitude, the
measured data cannot be compared to those of other weather stations on different altitudes for functional reasons.
This is what the relative barometric pressure is used for. The actually measured barometric pressure (= absolute
barometric pressure) is converted to sea level depending on altitude.
However, you cannot enter the actual altitude at the site of setup in the base station. Instead, you can set the relative
barometric pressure for your area using the calibration (see
TING"; set value "REL BARO OFFSET").
You can find the required barometric pressure value, e.g. online on various websites. Sometimes, the cur-
rent barometric pressure is also displayed on your municipality's website.
70
" (4) buttons to select the display range for barometric pressure (see
chapter 11. c), setting "TIME SETTING", subfunc-
Full moon
".
chapter 11. c), Setting function "CALIBRATION SET-
chapter 7. b), item 15),