Cavitron; System Controls; Main Screen; Settings Screen - Dentsply Sirona Cavitron 300 Serie Gebrauchsanweisung

9. Cavitron

300 Series Ultrasonic Scaler
®

9.1 System Controls

Diagnostic Display
See section 9.2 for more details.
Purge
Purge mode is used to flush
waterlines. Runs automatically
for 2 minutes (Page 9).
Rinse
Rinse mode is for use
during an ultrasonic
scaling procedure when
lavage is desired with no
cavitation (Page 9).
Ultrasonic Power Level
Control
Slide to select the
desired ultrasonic power
level for operation.
Sliding up increases the
power level and sliding
down decreases the
power level.
Settings Icon
Allows you to adjust
settings for the foot
pedal and screen
brightness. Press and
hold until the Settings
screen appears.
Power On Indicator
Tap-On™ Wireless Rechargeable Foot Pedal
Eliminates the need to hold down or pump foot pedal.
See section 9.5 for more details.
9.2 Diagnostic Display Indicators and Control

Main Screen

1.
Main Power ON/OFF Switch
2.
ON/OFF Switch located on
the rear of the system.
Steri-Mate 360 Handpiece
®
Accepts Cavitron 30K
®
Ultrasonic inserts. It is
not compatible with the
3.
Cavitron 30K Slimline metal
grip type inserts (30K SLI-
10S, SLI-10L and SLI-10R).
See section 9.3 for more 4.
details.
Preset Power Modes
Handpiece Holder
Securely holds the system's
handpiece, or cable
9.
connector when handpiece
is not installed.
Lock / Unlock
Press and hold to lock or
unlock the screen. Screen will
appear dimmed when locked.

Settings Screen

Detachable Featherweight
Handpiece Cable
Cable can easily be detached
from unit as needed for
replacement.
10.
11.
12.
English - 7
1. Service
Cable or handpiece issue.
Unit overheating. Stop use and contact Cavitron Care.
5.
2. Filter
Icon will appear when water filter needs to be replaced. Once replaced, press
and hold to reset indicator.
3. Purge
Purge mode is used to flush waterlines. Runs automatically for 2 minutes.
This screen shows when purge is activated.
• Scale Icon - press to return to main screen
• Depress foot pedal to return to main screen
• Main screen will appear when countdown is complete
4. Rinse
Rinse mode is for use during an ultrasonic scaling procedure when lavage is
6.
desired with no cavitation.
This screen shows when rinse is activated. Depress foot pedal to
8.
begin rinse mode cycle.
• Scale Icon - press to return to main screen
5. Foot Pedal Battery
Indicates battery life of foot pedal.
7.
6. Preset Power Modes- Programmable
Press and hold until sound indicator is heard.
7. Lock / Unlock Icons
Press and hold to lock or unlock screen. Screen appears dimmed when locked.
8. Power Level Icon
Adjust number to desired power level by swiping in an upward or downward motion.
• Power levels set between 05 and 35 are within Blue
9. Settings
13.
Press & hold until settings screen appears.
10. Scale
Press to return to main screen
11. Tap-On
Press to activate or inactivate Tap-On™ Technology
Note: Tap-On is inactivated at the factory.
12. Sync
Press to synchronize foot pedal and unit
Note: If the foot pedal is synced to the unit, pressing the sync icon will unlink the
foot pedal from the unit.
13. Brightness
Sliding up and down will increase or decrease brightness level
Zone range
English - 8