Troubleshooting - BOMANN KB 7346 Bedienungsanleitung, Garantie

Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise, it can be damaged.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
A permanently high power level can lead to in-
creased ice formation
wipe out the interior of the appliance.
Replacing the door hinge
If the appliance door starts to stutter, crack or jam
when you open it, it is probably due to a worn or
damaged hinge.
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
beckoning.
• Remove the contents of the appliance and the
movable interior parts.
• Tilt the appliance backwards and block it in this
position to prevent the door from sliding out.
• Loosen the hinge cover as described under
versing the door opening"
upper door hinge.
• Turn out the stand and disassemble the lower
door hinge.
• The respective hinge assembly is carried out in
reverse order.
→ set a lower power level and
and disassemble the
• Open and close the appliance door for a test run,
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
Before you contact an authorized specialist
Problem / cause / action
Appliance is not working properly or at all
- Check the power supply / temperature setting /
ambient temperature.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
the unit in the last 24 hours.
- The appliance door is not closed properly, check
the door seal.
Loud noise during operation
- Check that the appliance is level.
"Operating noise"
- See
Water on the appliance bottom
- Check the temperature setting / water discharge
channel or opening.
NOTE:
If a problem persists after following the steps above,
contact your trader or an authorized technician.
"Re-
23

Troubleshooting

.