Grasslin Talento Taxxi Bedienungsanleitung Seite 12

5
Hold the taxxi directly
on the two IR diodes
(hold the hand programming
unit still during this operation)
Press the corresponding key twice, depending on the transfer direction –
in or out
•
•
If the data has been correctly transferred, the number of the program location,
e.g. P_ 1, can be seen in the display (of the hand programming unit).
If the data has not been correctly transferred, there is a short, audible signal and
the corresponding error message appears in the display (see Section 5).
Press the key once. The transfer is prepared and the relevant program
location and the assignment
in or out flash alternately
Press the key again. The data is transferred. An audible signal (continuous
tone) is output during the transfer.
GB