Setting The Time; Using The Blinds - Dometic FreshLight 2200 Bedienungsanleitung

Operating the roof air conditioner
9.14

Setting the time

The remote control needs the current time in order to program the timer. The
time is indicated on the display of the remote control.
Perform the following steps to set the time:
I
Note
The remote control returns to its initial mode if no key is pressed on
the remote control for ten seconds while setting the time.
➤ Press and hold the CLOCK button to go to the mode used to set the time.
✓ The time flashes on the display of the remote control.
➤ Use the + or – button to set the current time.
➤ Press the SET button to confirm the time.
9.15

Using the blinds

A
NOTICE! Beware of damage
The blackout blind may not be closed completely if the vehicle is
standing in the blazing sun. There is a danger of heat
accumulation. In order to prevent damage, the blackout bind must
remain open by at least one third.
The two blinds can be used to control the sun and light penetrating the
vehicle.
➤ Move the blinds manually (fig. 7, page 5).
60
Dometic FreshLight
EN