PeakTech 3340 Bedienungsanleitung Seite 46

WARNING!
To avoid electric shock, disconnect all leads from any
equipment before you remove or install the battery.
Follow these steps to install the battery.
1. Turn off the power and disconnect all test leads.
2. Set the Rotary Selector Switch to the Ω - position.
3. Remove the screws to open the battery compartment.
4. Place the battery inside the insulation capsule and snap it
on to place.
WARNING!
Do not discard the provided battery insulation capsule. If you
do not use this insulation capsule properly, it might cause
damage or injury.
WARNING!
Do not operate the meter until you replace the battery and
close the battery compartment cover.
Statutory Notification about the Battery Regulations
The delivery of many devices includes batteries, which for
example serve to operate the remote control. There also could
be batteries or accumulators built into the device itself. In
connection with the sale of these batteries or accumulators, we
are obliged under the Battery Regulations to notify our
customers of the following:
-45-