Troubleshooting - Pari 047 Gebrauchsanweisung

Always disconnect the compressor from the mains for storage
because electrical devices that remain plugged in present a po-
tential hazard source.
5

TROUBLESHOOTING

In the event of faults that are not listed in this chapter, or if the
suggested procedure does not correct the fault, contact the
PARI GmbH Service Center.
Fault
The
compressor
does not start
up.
No
medication is
coming out of
the nebuliser.
All LEDs are
flashing
– 45 –
Possible cause
The power adapter cable
is not plugged into the
device properly.
The power adapter is not
plugged into the mains
socket properly.
The nebuliser nozzle is
blocked.
The connection tube is
not connected properly.
The connection tube is
leaking.
There is a temporary
fault in the rechargeable
battery.
Procedure
Check that the power
adapter cable is seated
correctly in the
compressor power cord
socket.
Check that the power
adapter is seated
correctly in the mains
socket.
Clean the nebuliser.
Check that both ends of
the tube are seated
properly.
Replace the connection
tube.
Reset the rechargeable
battery as described in
the instructions for use of
the battery.