Repairing; Storage - Pari 047 Gebrauchsanweisung

To replace the filter, proceed as follows:
• Unscrew the filter holder from
your compressor using a suit-
able coin.
• Pull the old filter out of the filter
holder and fit the new filter in
its place.
• Reinsert the filter holder together with the new filter in your
compressor and screw it tight with the coin.

4.3 Repairing

The compressor must only be serviced by the PARI GmbH
Technical Service department or a service centre expressly au-
thorised by PARI. If the compressor is opened or manipulated
by anyone else, all claims under the warranty shall be void. In
these cases, PARI GmbH will also accept no liability.

4.4 Storage

NOTICE
Damage to the power adapter cable by kinking
If the power adapter cable is wound or bent very tightly, the
wires inside the cable may break. This will render the cable
unusable.
• Do not wind the power adapter cable around the com-
pressor.
• Disconnect the power adapter cord from the compressor
and wind it up.
• Disconnect the rechargeable battery from the compressor.
Store the compressor and accessories safely out of continuous
direct sunlight.
– 44 –