Troubleshooting - Pari JuniorBOY SX Gebrauchsanweisung

5

TROUBLESHOOTING

In the event of faults that are not listed in this chapter, or if the
suggested procedure does not correct the fault, contact the
PARI GmbH Service Center.
Fault
The
compressor
does not start
up.
No
medication is
coming out of
the nebuliser.
Possible cause
The power cord is not
plugged into the device
properly.
The power plug is not
plugged into the mains
socket properly.
The nebuliser nozzle is
blocked.
The connection tube is
not connected properly.
The connection tube is
leaking.
– 68 –
Procedure
Check that the power
cord is seated correctly
in the compressor power
cord socket.
Check that the power
plug is seated correctly
in the mains socket.
Clean the nebuliser.
Check that both ends of
the tube are seated
properly.
Replace the connection
tube.