Disposal Of The Old Device - CASO DESIGN VRH 590 advanced Original Bedienungsanleitung

A complete vacu-
um is not being
created in the bag.
The bag is not
being welded
correctly
The bag does not
hold the vacuum
after it has been
welded shut
The sealing bar
seals even before
the end of the
vacuum sealing
process.
PLEASE NOTE

If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
9

Disposal of the Old Device

To protect the environment, it's important to dispose of old electronic devices
properly. Do not place your old unit in the non-recyclable waste under any
circumstances.
The open end of the bag is not
completely inside the vacuum
chamber
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is overheating
so that the bag melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
The weld seam is not sealed all
the way through.
The food inside the bag has
formed gases.
The sealing bar has become
too hot due to too many
passes in quick succession
and is sealing the bags even
though not all the air has been
extracted.
Position the bag correctly
Select another bag
Clean the seals and retry cor-
rectly once they are dry
Open the cover on the unit
and let it cool down for a few
minutes
Select another bag; wrap paper
serviettes around any sharp
edges on the content
Open the bag again and clean
the upper internal part of the
bag and remove any foreign
matter that might be on the
welding bar before you weld
the bag shut again.
Cut off the seal and start the
vacuum and sealing process
again.
Blanch vegetables such as
cabbage and broccoli before
vacuum sealing them.
Open the cover on the unit
and let it cool down for a few
minutes
CASO VRH 590 advanced
DE
EN
FR
IT
ES
NL
PORT
RUS
DK
35