Description Of The Appliance; Quick Reference; Attaching The Accessories - Kärcher KST 2 Kurzanleitung

Description of the Appliance

The scope of delivery of your appliance is illustrated on
the packaging. Check the contents of the appliance for
completeness when unpacking.
In the event of missing accessories or any transport
damage, please contact your dealer.
 Illustrations on fold-out page!
A1 Indicator lamp (green) – line voltage is on
A2 Indicator lamp - heater (ORANGE)
A3 Safety cap
A4 Holder for accessories
A5 Storage holder for floor nozzle
A6 Mains cable with mains plug
A7 Running wheels (2 ea.)
A8 Steering roller
B1 Steam gun
B2 Unlocking button
B3 Selector switch for the steam volume (with child
protection)
B4 Steam lever
B5 Steam hose
C1 Detail nozzle
C2 Round brush
D1 Hand nozzle
D2 Microfibre cloth cover
E1 Extension tubes (two tubes)
E2 Unlocking button
F1 Floor nozzle
F2 Retaining clip
F3 Microfibre floor cloth

Quick Reference

 Illustrations on Page 2
Illustration
 Unscrew the safety lock and fill the steam cleaner
with a max. of 1 litre of water.
Illustration
 Screw in safety cap.
Illustration
 Plug in the mains plug.
The green and orange indicator lights are on.
Illustration
 Wait until the orange indicator lamp goes out.
Illustration
 Connect the accessories to the steam gun.
The steam cleaner is ready to use.
Black

Attaching the Accessories

Illustration
 Insert steering roller and transport wheels and lock
them.
Illustration
 Connect the required accessories (see Chapter
"How to use the accessories") to the steam gun. In-
sert the open end of the accessory on the steam
gun and push onto the steam gun until the unlock-
ing button of the steam gun locks into place.
Illustration
 Use the extension tubes if necessary. To do so,
connect one or both extension tubes to the steam
gun. Insert the required accessories on the free
end of the extension tube.
Removing the Accessories
 Move the selector switch for the steam volume
back (steam lever locked).
Illustration
 To detach the accessory parts, press the unlocking
button and pull the items apart.
Notes
 In case of continuous use of commercially available
distilled water, no descaling of the boiler is neces-
sary.
 You can reduce the heating-up time by using warm
water.
 Remove the safety lock from the device.
Illustration
 Completely empty the steam boiler to remove exist-
ing water.
 Fill the boiler with a maximum of 1 liters of fresh tap
water.
 Screw the safety cap back onto the device.
Turning on the Appliance
 Place the unit securely on a firm surface.
 Insert the mains plug into a socket.
Both indicator lamps must illuminate.
 The orange indicator lamp goes out after approxi-
mately 8 minutes.
The steam cleaner is ready to use.
Adjusting the Steam Quantity
Use the selector switch for the steam volume to regulate
the discharged steam. The selector switch has three po-
sitions:
Maximum steam volume
Reduced steam volume
No steam - child protection
Note:
In this lever position, the steam lever cannot be
used.
 Set selector switch to the required steam volume.
 While operating the steam switch, always direct the
steam gun at a separate piece of cloth until the
steam is emitted evenly.
Note:
– 6
EN
Operation
Fill up with water
11