Motor Run-In Screen - GRAUPNER 6444 Allgemeine Einführung

9. MOTOR RUN-IN SCREEN (Warning: only use DC brushed motors or DC fans!)
9-1. MOTOR Break-In
- This is motor brake in mode.
- Rotate the motor keeping the selected voltage.
- Set voltage and operating time.
- Set 0.1V~24V
Make sure not to exceed 12V when breaking in motor used for electric power.
12~24V range is for operating range of fan.
The motor function can only be started, if the other output is not in use!
For racing brushed motors and using the internal power supply, we
recommend to use a 1-2 Ohm resistor in series of the motor to reduce the max.
current flow.
Use voltages of max. 7.2V for 7.2V motors. Never use a higher voltage as the
motor is build for.
Higher voltages can destroy the motor and the charger. Never run brushless
motors!
9-2. Program Mode
- This mode is to program motor voltages.
- It consists of 4 steps, and user can set operation voltage, operating time and
pause time in each step.
- The meaning of "SPEED" is speed which reaches the selected voltage when step
is changed.
- Cycle can be set and it can be repeated in 1~4 step.
9-3. MOTOR Test
- Rotate the motor at 4.8V or 7.2V.
- Showing average currents and peak currents in each step.
- Step operation voltage
SPEED can be set to 1~5 and 1 is slowest and 5 is fastest. The slowest
speed is recommended for motors.
Cycle can be set to 1~10 times.
1st - 1.2V
2nd - 2.4V
3rd - 3.6V
4th - 4.8V
5th - 6.0V
6th - 7.2V
Page 34/53