GRAUPNER 6444 Allgemeine Einführung Seite 82

1. MEMORY AND BATTERY SETUP MENU SCREEN
1-1. Memory selection
- Pressing the dial in Memory[00] then rotate the dial to select the wanted memory.
- Memory 0, 1-50 can be selected.
- "0" Memory automatic mode can be selected at the same time in either channel 1
1-2. Battery selection
- In memory screen, select the memory and press "-> button"
- Set your wanted battery, cell or voltage, and capacity.
If battery type is changed, all setting parameters should be initialized, and TRACE
DAT in DAT VIEW mode is clear.
- Input the purchasing date of your battery (day/month/year)
- In "0" memory, if battery type is changed then press the dial, it should move
"CHARGE SETUP".
1-3. Battery Name Setting
- You can name your battery pack using up to total 16 letters.
1-4. Auto settings on parameters
- When battery type is changed
- max. current:
In any outputs, 0, 1-50 Memory can be selected, but memory room which is
selected by counter output can not be selected.
or channel 2.
The datas of Memory [0] are not stored into the data memory. Only the
battery type is stored.
In Automatic mode, main screens will be only shown as like order -
MEMORY CHARGE
If battery type is changed, the purchasing date on your battery should be
automatically changed to present date.
It should be clear to battery initial values.
The max. Charge or discharge current should be changed to 1C rate.
Safety timer value is automatically changed.
However, battery type and max. charge current MUST be set correctly.
Page
DISCHARGE DATA VIEW
18/53
CONFIG