GRAUPNER 6444 Allgemeine Einführung Seite 104

This is only for NiCD/NiMH battery.
Charging has to be NOT "OFF" during charging, this charge has
to be continued.
This charge mode is very sensitive to charge cable connection,
so if connected cable is touched, charging could be finished.
Since delta peak is detected every second, it is possible to check
delta peak accurately.
It is possible to finish charging without increasing battery
temperature as ZEROpeak can be detected in this charge mode.
Charging is off 10 minutes after charging and gain battery internal
resistance.
e. GMVIS
This is only for NiCd/NiMH battery.
Charging every 6 seconds and pause every 2 seconds at the
intervals of 8 seconds.
Charging every 2 seconds and pause every 6 seconds at the final
stage of charging to prevent battery from being overheated or
venting.
f. IMPULSE
This is only for NiCd/NiMH battery. Battery power could be
improved, mainly with old batteries.
Refer to IMPULSE 5-7 above.
g. REPLEX
This is only for NiCd/NiMH battery. Battery power could be
improved, mainly with old batteries, but the life time could be
reduced.
Refer to REFLEX 5-8 above.
h. REPEAK
This is only for NiCd/NiMH battery. REPEAKING can be
dangerous, if the battery is still warm.
Refer to REPEAK CYCLE 2-8 above.
i. CC/CV
This is only for Lilo/LiPo/LiFe/Pb battery
CC to CV method. (CC = constant current, CV = constant voltage)
If balancing cable is connected to the balancing port of the
charger, charging can be very stably proceeded and finished as
the charger can use voltage measured at the balancing cable.
Page 40/53