Operation Menu Screen - GRAUPNER 6444 Allgemeine Einführung

13. OPERATION MENU SCREEN

13-1. CHARGE, DISCHARGE OPERATION SCREEN
a. OPERATION SCREEN
< DISPLAY 1 >
< DISPLAY 2 >
- This is shown during CHARGE, DISCHARGE, STEP-CHARGE, CYCLE
operating.
resistance, batt. Temp.)
- Selected current can be changed during operating.
Current can be changed in NORMAL, LINEAR, REFLEX, CC/CV,
CV-LINK charge modes.
Current can be changed in NORMAL, LINEAR, LINK discharge
mode,
Current can not be changed simultaneously in both charge or
discharge LINK mode.
- EXP.FINSH
Expected finished time is indicated.
This should be not shown in Auto, charge/discharge,
cycle, REPEAK CHG operation.
- FINISH TIME
When operation is finished and END**** is shown, time is
indicated.
This should be not shown during operation.
- CLOCK, DATE
Showing present time and date.
- CHG POWER RATE setting
Can set wattage rate of two outputs.
While charging is being proceeded in both outputs, and if wattage
is
increased in one output, the wattage of the counterpart output is
accordingly decreased.
Delta Peak could be detected due to the sudden wattage change
in NiCd/NiMH mode.
DC power used value could vary depending on using AC or DC
input power.
It is also to vary depending on the internal charge wattage.
Page
(Operation Time,
49/53
capacity, voltage, current,