Exsys EX-61004 Anleitung Seite 26

English
7. Server Settings
3. Serial Port Settings - Einstellungen für die serielle Schnittstelle
Alias
Interface type
Baud rate
Data bit
Parity check
Stop bit
RST Control
Interval time
Packing length
Delimiter enabling
Delimiter
Delimiter handling
Apply to all serial ports
© Copyright 2023 by EXSYS Vertriebs GmbH. All rights reserved
Set the serial port alias
Interface type (RS232/485/422)
Serial port baud rate (the value should be the same as the baud rate of the device
connected)
Data bits (the value should be the same as the baud rate of the device connected),
default is 8
Check bits (none, even, odd), (the value should be the same as the baud rate of
the device connected), default is none
Stop bit (the value should be the same as the baud rate of the device connected),
default is 8
Auto, XON/XOFF, CTS/RTS can be selected
Data packing interval (if required, default is 0)
Length of data pack (if required, default is 0)
Enable packet separation by delimiter if required
Set the encoding of the delimiter for the transmitted data (0-0xff)
Chose to keep und discard
Applies the settings for all serial ports of the device server
26
EX-61004