Installing The Batteries In The Remote Control; Using The Remote Control - Yamaha MCR-E810 Bedienungsanleitung

Installing the batteries in the remote
control
Press
1
Press the mark on the battery cover and
open the cover.
2
Insert the two supplied batteries (AA, R06,
UM-3) into the battery compartment.
Make sure you insert the batteries according to the
polarity markings (+ and –).
3
Close the battery cover.
Notes
• Do not use an old battery together with new one.
• Do not use different types of batteries (for example, alkaline
and manganese) together. Each type of battery has its own
characteristics even if they are similar in shape.
• If the batteries run out, immediately remove them from the
remote control to prevent an explosion or acid leak.
• Dispose of the batteries according to the regional regulations.
• If a battery starts leaking, dispose of it immediately. Be careful
not to let leaking battery acid come into contact with your skin
or clothing. Before inserting new batteries, wipe the
compartment clean.
• Replace the batteries within two minutes to preserve the
memory in the remote control.
All manuals and user guides at all-guides.com
Use the remote control within 6 m (20 feet) of the
component you want to control and point it toward its
remote control sensor (see pages 3 and 6).
Notes
• Be careful not to spill liquid on the remote control.
• Be careful not to drop the remote control.
• Do not leave the remote control in the following places:

Using the remote control

TIMER
STANDBY/ON
Within 6 m
(20 feet)
30˚
– hot or humid places, such as near a heater or in a bathroom
– extremely cold places
– dusty places
Controls and Functions
NATURAL SOUND STEREO RECEIVER RX-E810
PURE DIRECT
DISPLAY MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING
VOLUME
TIME ADJ TIMER HOUR MIN
INPUT
BASS TREBLE BALANCE
PHONES
L R
MIN MAX
30˚
11
En