Sony DSC-1024HD Bedienungsanleitung Seite 42

Remote sensor
SIGNAL FORMAT
on SPATS See a }
[es ES ELSE 8 CC
COMMAND MODE selector
This unit accepts wireless or wired remote commanders for
Sony monitors, TVs and projectors.
Setting the type of the remote commander
Set the COMMAND MODE selector according to the type o
the remote commander.
TV: Sony monitors' or TVs' Vv
commander PJ
PJ: Sony projectors' commander bane
OFF: When not using the remote COMMAND
: 8 . MODE
commandder, set to this
position to avoid malfunction.
Available remote commander operations
The following operations can be controlled by the remote
commander.
¢ Power on/off
Input selection
Picture adjustments: contrast, phase and chroma
On-screen display on/off (only for video monitors and TVs)
Menu operations (See the right column.)
Direct memory loading (See the right column.)
The available operations and the buttons to be used for each
operation are limited depending on each remote commander.
See the table below.
Direct memory loading
The remote commander can quickly call up the adjustment
data stored in the memory.
1 Press buttons 7, 7, 7 and ENTER on the remote
commander in sequence at intervals of one second.
The "MEMORY LOAD READY" appears on the screen.
2 Select the memory number (1 to 5) you want to call up
using the number button.
The converter is adjusted to the selected memory data.
f
To cancel the operation
Press buttons 0, 0,0 and ENTER on the remote commander in
sequence at intervals of one second. The "MEMORY LOAD
EXIT" appears on the screen.
The direct memory load operation is also cancelled by turning
off the unit.
Be sure to press buttons 7, 7,7 and ENTER, or 0, 0,0 and
ENTER at intervals of about one second.
If more than 3 seconds elapse between two presses, the
operation will be cancelled. In this case, start again.
Menu operation using the remote commander
The menu screens for the remote commander are different
from those for the main unit.
When you press the menu button (MENU, PAGE or 4) on the
remote commander once or twice, the GEOM MENU or
COLOR MENU appears respectively.
Select the item with the #/# button and press the enter button
(ENTER, = or M SEL) on the remote commander. Then
adjust the selected item using the #/# button.
Remote commander model | RM-854 RM-1271 RM-P31292 RM-PJ350 RM-PJC520
COMMAND MODE setting TV Py Py Py Py
Input selection INPUT SELECT 1 LINE] VIDEO VIDEO VIDEOI 1
INPUT SELECT 2 | LINE2 A A VIDEO2 2
INPUT SELECT 3 LINE3 B B RGB 3
Menu operation MENU MENU PAGE or ] PAGE or PAGE or PAGE ]
ENTER ENTER > > > ' MSEL.
CENTG t i *# '| t t | ¢
CENTS
+
+
+
m7
ry
Picture adjustment [| CONTRAST CONTRAST CONTR CONTR CONTR CONTR
CHROMA «ss CHROMA s o [ * COLOR COLOR: COLOR | a "
| PHASE PHASE HUE HUET |
a'y