Werbung
Verfügbare Sprachen
Verfügbare Sprachen
[4] VIDEO OUT connector section
Three sets of video outputs.
The converted signal is
output from this section.
YIC output (4-pin):
Connect to the Y/C input of video equipment.
Only the NTSC or PAL signal is output from this
connector.
Composite video output (BNC type):
Connect to the composite video input of video equipment.
Only the NTSC or PAL signal is output from this
connector.
RGB/component output (D-sub 15-pin, 3-row):
Connect to the RGB or component (Y/B-Y/R-Y) inputs of
video equipment.
RGB/YBR output selector:
Set this selector depending on the format of the signal
output from the D-sub connector. YBR is effective when the
NTSC or PAL signal is output.
SYNC output selector:
Select the sync signal for the RGB output.
Set to SEP to use separate horizontal /vertical syne signal.
Set to COMP to use the composite sync signal.
[5] AUDIO IN UR jacks (RCA pin)
Three sets of audio inputs.
Connect to the audio output jacks of equipment. If the
input source is monaural, connect it to the L jack only.
You can select the audio input with the INPUT SELECT
buttons on the front panel.
AUDIO OUT LR jacks (RCA pin)
A set of audio outputs.
Connect to the audio input jacks of equipment.
my]
CTRL S$ IN/OUT jacks (minijack)
Connect to the CONTROL S jacks of other Sony equipment.
It is then possible to control the whole system with a single
remote commander.
When a plug is connected to the CTRL S IN jack, the
remote sensor on the front panel becomes inactive.
AC IN connector
Connect the supplied power cord.
22
Werbung
