Specifications; Additional Safety Rules - Makita JS1660 Betriebsanleitung

ENGLISH
1 Screw
2 Screwdriver
3 Center blade
4 Hex wrench

SPECIFICATIONS

Model
Max. cutting capacities
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
Min. cutting radius ...................................................... –
Strokes per minute ..................................................... 4,500
Overall length ............................................................. 304 mm
Net weight ................................................................... 1.3 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
Safety instructions.

ADDITIONAL SAFETY RULES

1. Hold the tool firmly.
2. Secure the workpiece firmly.
3. Keep hands away from moving parts.
4. Edges and chips of the workpiece are sharp.
Wear gloves. It is also recommended that you
put on thickly bottomed shoes to prevent
injury.
5. Do not put the tool on the chips of the work-
piece. Otherwise it can cause damage and
trouble on the tool.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
8. Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
9. Avoid cutting electrical wires. It can cause
serious accident by electric shock.
SAVE THESE INSTRUCTIONS.
4
Explanation of general view
5 Side blade
6 Bolt
7 Pin
2
............................................ 1.6 mm/16 ga
2
............................................ 1.2 mm/18 ga
2
............................................ 0.8 mm/22 ga
2
.................................... 2.5 mm/13 ga
JS1660
OPERATING INSTRUCTIONS
Adjusting the blade clearance (Fig. 1 & 2)
For JS1660 Only
Important: Always be sure that the tool is switched off
and unplugged before adjusting the blade clearance.
Adjust the clearance between the side blade and the
center blade according to the thickness of the work-
piece.
First use a screwdriver to loosen the screw.
Then use the hex wrench to adjust the clearance by
tightening or loosening the bolt. There may be a slight
difference between clearances (A) and (B).
Check the smaller clearance with the thickness gauge
and adjust it.
When using the thickness gauge to adjust the blade
clearance, refer to the table below.
ENB011-2
Workpiece thickness
Less than 0.8
0.8 – 1.3
More than 1.3
After adjusting the clearance, tighten the screw
securely.
Lubrication (Fig. 3)
Before operation, lubricate the contact point of the
center blade and the pin. To keep good cutting
performance, also use a cutting lubricant from time to
time during operation.
8 Slide switch
9 Limit mark
0 Brush holder cap
JS1670
1.0 mm/20 ga
0.7 mm/23 ga
0.5 mm/26 ga
2.5 mm/13 ga
30 mm
4,500
306 mm
1.3 kg
(mm) thickness gauge
Marking on
0.5
1.0
1.5