TECHNICAL SPECIFICATIONS (CONT)
Cooling time of the device when it has been stored at 45°C
for it to be ready for use at ambient temperature (20°C)
dimensions
actiTENS
Weight of
actiTENS
charging case dimensions
actiCHARGE
charging case weight
actiCHARGE
IP classification
actiTENS
charging case IP classification
actiCHARGE
Waveform
Pulse width
Frequency
Sessions length
Electrode
electrode storage conditions
actiTENS
sensitive skin electrodes storage conditions
actiTENS
self-adhesive strip storage conditions
actiTENS
Composition
actiTENS
Composition
actiTENS
Composition of the sensitive skin electrodes
Composition of the low back electrode
Composition of the standard electrode
self-adhesive strip
textile accessories
10 minutes minimum
108 mm x 53.5 mm x 17 mm
~ 65 g
133.8 mm x 79 mm x 34 mm
~ 115 g
IP22: protection against solid bodies greater
than 12.5 mm, protection against dripping
water up to 15° from the vertical
IP21: protection against solid bodies
greater than 12.5 mm, protection against
vertically dripping water
Compensated asymmetric two-phase waves
50-400 µs ± 5 µs
1-120 Hz ± 10%
10 min-12 h adjustable with the mobile
app
Any electrode in which the current density
exceeds 2 mA/cm
requires special attention;
2
stimulation should never be painful.
From 5°C to 35°C with relative humidity
from 30 % to 80 %
From 5°C to 27°C
From 0°C to 40°C
Medical grade silicone
Main fabric: Polyamide 58%, Polyester
30%, Elastane 12%
Label: Polyamide 90%, Polyester 10%
Buckle and Velcro: Polyamide
Biocompatible hydrogel conductor formulated
for sensitive skin, conducting part: silver,
insulating base material: water repellent fabric,
snap connector: stainless steel
Biocompatible hydrogel conductor,
conducting part: vinyl carbon; insulating
base material: non-woven PET 25 microns,
Velcro: Velour 3165, snap connector:
stainless steel 316
Biocompatible hydrogel conductor,
conducting part: carbon + PE; insulating
base material: non-woven PET fibre, snap
connector: stainless steel
91