Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
6.6 CONTROL SETTINGS AFTER INSTALLING CORNER COVER WITH MOTION SENSOR
(PC-ARFP1E EXAMPLE)
Depending on the location of the corner with motion
sensor, setting on the wired controller is also necessary.
1 Press and hold "Menu" and "Back/Help" simultaneously for
at least three seconds with power applied and the indoor unit
is not operating. The Test Run menu will be displayed.
Test Run Menu
Test Run
Function Selection
Thermistor Selection
Input/Output
Function 5
Sel.
2 Select "Function Selection" from the Test Run menu and
press "OK".
3 Select the indoor unit by pressing "
Note: (This screen is NOT displayed when only one indoor
unit is connected to the wired controller. In this case, move
to 4.)
Function Selection
01-01
01-02
01-03
01-04
Sel.
6.7 WIRING CONNECTION FOR AIR PANEL
1 The following connectors are used in the air panel. Remove
the tape fixing the wiring connectors on the air panel and pull
out them as shown in the figure below. Connect them with
the wiring connectors on the indoor unit.
Electrical box
7
PMML0569 rev.0 - 01/2021
01
/
03
Entr
Rtrn
OK
Back
" and press "OK".
All
Entr
Rtrn
OK
Back
Condition without air
intake grille
Motor wiring for auto louver (on
air panel) (connector for low
voltage: 18 poles, white)
Motor wiring for auto louver (on
indoor unit) (Connector for low
voltage: 18 poles, white)
4 Press "
" and select "L1".
Function Selection:01-03
Item
b1
b2
b3
b4
b5
Sel.
Set "L1" according to the table below by pressing "
and press "OK".
When the products are shipped, the menu key should be
set to "L1=00", which indicates motion sensor is located at
stamp A.
Figure without corner covers
Stamp D
Refrigerant pipe
connection
Stamp C
Do not install in the "Stamp C" position
L1
00
01
02
03
2 After completing the wiring connection of the air panel,
attach the air inlet grille. Perform the attaching work in the
reverse procedure of removing.
Setting
00
01
00
/
00
00
17
00
OK
Back
Adj.
Entr
Rtrn
Attaching Place (Stamp)
A [No Setting Required]
B
Not Available
D
"
Stamp A
Attached
location (as
shipped)
Stamp B
Werbung
Inhaltsverzeichnis
