Startup / Operation - BOMANN GS 2196.1 Bedienungsanleitung, Garantie

 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
 Ask another person to assist.
You possibly need:
screw wrench, Phillips screw-

driver as well as a thin-blade screwdriver.
 Loosen the screws on the appliance back and
remove the appliance cover.
 Dismount the upper door hinge and the screws
(s). Lift the appliance door and set it safely aside.
 Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet and disassemble
the lower door hinge.
 Transfer and attach the lower door hinge to the
opposite appliance side. Screw in the feet accord-
ingly.
All manuals and user guides at all-guides.com
 Put the appliance back in the upright position.
 Transfer and attach the upper door hinge to the
 Replace the appliance cover and fix it.
 Dismount the door handle and attach it to the
Check that the door is optimally aligned both vertical-
ly and horizontally to ensure a smooth opening and
closing of the door.
Prior to first use
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance
 Connect the appliance to the power supply.
 Operate the temperature control. See also the
Settings
The power levels [ COLD – COLDER ] regulate the
different values of the internal temperature.
18
Put on the appliance door and fix it its intended
position.
opposite appliance side after unscrewing the
hinge pin and inserting it into the adjacent hole.
Screw in the screws (s) on the opposite side.
corresponding other door outer side. Refer to the
instructions in "Mounting the door handle". Trans-
fer the cover caps on the exposed holes to the re-
spective other door outer side.

Startup / Operation

CAUTION:
section "Settings".