Startup / Operation - BOMANN GS 2196.1 Bedienungsanleitung, Garantie

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
The power levels control the different values of the
internal temperature.
Power level
lowest level,
COLD
warmest internal temperature
medium level,
MID
optimal operating temperature
highest level,
COLDER*
coldest internal temperature
*Beware of high settings: the compressor is running contin-
uously.
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
For initial operation, first set the lowest possible inter-
nal temperature (= highest power level) until the ap-
pliance has reached the desired operating tempera-
ture. It is recommended to reset to a medium power
level afterwards, then you can easily make any tem-
perature correction.
Recommendation, for optimized food storage and to
avoid food waste, a medium power level is generally
best. A high power level also increases energy con-
sumption.
To be able to check the cooling performance, you
ideally need a freezing thermometer. Place it in the
appliance.
The ideal temperature is -18°C. A less cold tempera-
ture setting may shorten food durability.
.
Equipment
Note that the equipment varies depending on the ap-
pliance type.
The various shelves or drawers can be removed for
individual storage. Also practical for cleaning pur-
poses.
NOTE:
For the most efficient use of energy, place all
shelves/drawers in their original positions.
Removing / inserting the drawers
• To remove the drawer, pull it out to the front, in-
cline it if necessary and remove it.
• Insert the drawer, if necessary, lift the front part of
the drawer slightly and push it in completely.
Ice cube tray
Depending on the model, an ice cube tray for making
ice cubes is included with the appliance.
• Fill the ice cube tray about ¾ full of water. Then
place the tray flat in the freezer for a few hours.
22