Startup / Operation - BOMANN GT 7337 Bedienungsanleitung, Garantie

 Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
 Connect the appliance to the power supply.
 Set the operating conditions. See also the follow-
ing sections.
Control overview
.
1 Control lamp lights up
when the compressor is
running.
2 Temperature control
regulates the freezer
temperature.
Settings
Position [ 0 ] means that the appliance is in the
switched-off state. Turn the temperature control
clockwise from this position, the appliance switches
on automatically.
The power level [ 1 – 7 ] control the different values
of the internal temperature.
Power level Temperature range
1 approx. -8°C ∼ -12°C
2, 3 approx. -12°C ∼ -15°C
approx. -15°C ∼ -18°C
4
approx. -18°C ∼ -20°C
5, 6
approx. -20°C ∼ -25°C
7*
*Beware at level 7: the compressor is running continuously.
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
For initial operation, first set the lowest possible inter-
nal temperature (= highest power level) until the ap-
pliance has reached the desired operating tempera-
ture. It is recommended to reset to a medium power
level afterwards, then you can easily make any tem-
perature correction.
Recommendation, for optimized food storage and to
avoid food waste, a medium power level is generally
best. A high power level also increases energy con-
sumption.
To be able to check the cooling performance, you
ideally need a freezing thermometer. Place it in the
freezer basket.
The ideal temperature is -18°C. A less cold tempera-
ture setting may shorten food durability.
Equipment
The freezer basket facilitates the sorting of small-
sized frozen food and allows faster access to fre-
quently needed frozen food.
20