Installation Diagram; Hydraulic Connections; Electrical Connections - poolstar POOLEX O' SPA Installations- Und Gebrauchsanleitung

3.2

Installation diagram

Filter
SPA
Wall plug
230V 16A 10mA
The filter located upstream of the heat pump must be regularly cleared so that the water in the
system is clean, thus avoiding the operational problems associated with dirt or clogging in the
filter.
3.3 Hydraulic connection
Step 1
Screw the connectors for heat pump
3.4 Electrical connection
Pump's power plug integrates a 10mA differential
circuit breaker.
Regularly test the correct operation. In the event
of successive triggering or doubts contact the
after-sales service.
Before plugging in your heat pump, please ensure
the electrical socket is properly grounded and
protected from rain as well as water projections.
Press the RESET button to start the O'SPA heat
pump. The power indicator lights up in red: the heat
pump is on.
12 | EN
3. Installation
Control unit
Electric heater
Spa heater
control relay
Circulation
pump
Step 2
Connect the water inlet and outlet
TO THE SPA
Power
Test
indicator
Reset
RESET