Servicing; Replacing The Led Lamp Of The Kl 703 Motor - KaVo Kerr elements e-motion Bedienungsanleitung

Instructions for use elements e-motion Dental Motor
9 Servicing | 9.1 Replacing the LED lamp of the KL 703 motor

9 Servicing

Kerr recommends to use original parts for operation and repair only, since their
safety, function, and specific suitability have been tested in extensive tests.
Note
Kerr grants no guarantee of function and Kerr accepts no liability unless ori-
ginal replacement parts and operating materials are used exclusively.
Note
The device must not be serviced or repaired during operation/use.
Servicing work described in the following can be performed by the operator/
user.

9.1 Replacing the LED lamp of the KL 703 motor

Danger from hot lamp.
Risk of burn injury.
▶ Do not touch lamp after previous operation. Let the lamp cool off.
▶ Pull the sleeve off while twisting it slightly.
▶ Push the old KaVo Mini LED lamp out of the mount with your fingernail and
remove it.
▶ Inset the new KaVo Mini LED lamp into the recess such that the contact
surfaces align with those of the mount. Slide the lamp into the mount. Place
the sleeve on the motor and pull it up.
Note
The KaVo Mini LED lamp is a semiconductor element and must be operated
with direct current only. The lamp must be inserted with the poles in the cor-
rect orientation for the lamp to work properly.
CAUTION
48 / 58