Installation; Location; Installing The Instrument Tray - KaVo Kerr elements e-motion Bedienungsanleitung

Instructions for use elements e-motion Dental Motor
4 Installation | 4.1 Location

4 Installation

4.1 Location

Power supply and cords/hoses are on the floor.
Slipping and tripping.
▶ Power supply and cord/hoses need to be set-up/routed appropriately such
that they are not on the floor.
Note
To completely disconnect the device from the mains, the mains plug must be
pulled. For this reason, the unit must be set-up appropriately such that the
mains plug and the electrical outlet are easily accessible.
Note
Mind the electrical cord of the power supply! Route all cords appropriately
such that they do not get squashed, clamped or have a chair rolling over
them.
Note
Use the power supply in dry environments exclusively. Make sure that the
power supply is protected from the ingress of liquids.
▶ Place the product in an easily accessible place and visible for diagnostic pur-
poses.

4.2 Installing the instrument tray

The base plate of the instrument tray is preinstalled already on the right side of
the unit at the time of delivery. Optionally, the base plate can just as well be in-
stalled on the left side of the unit.
elements e-motion with preinstalled base plate
To be able to use the instrument tray, the attachment for the instrument tray
needs to be installed. The attachment can be plugged on in either direction onto
the metal bracket of the base plate.
Installing the attachment for the instrument tray
▶ Plug the attachment onto the metal bracket of the base plate.
CAUTION
24 / 58