Starting-Up The Motor; Operating The Elements E-Motion - KaVo Kerr elements e-motion Bedienungsanleitung

8:1 handpieces KaVo contra-
angle handpieces
1:1
KaVo SMARTmatic SMARTmatic S20
ENDO S81 (Mat. no.
(Mat. no. 1.011.6750)
1.011.6780)
Kerr elements 8:1 SMARTmatic S20 S
(Mat. no. (Mat. no.
1.011.6786) 1.011.6752)

6.3 Starting-up the motor

▶ Press the foot control to start the motor.
ð
The motor rotates at the speed and motion set on the display.

6.4 Operating the elements e-motion

Note
Please note the transmission/reduction ratio of the attached handpieces as
these have an impact on the displayed speed and the display torque of the
clamped tool.
The transmission ratio selected on the device is inconsistent with the
transmission ratio of the handpiece.
Risk of injury from files rotating too fast.
▶ Make sure that the handpiece you use and the setting of the transmission
ratio are consistent.
Note
The control of the device is matched to the efficiency of the following hand-
pieces. Speed and torque can be assured only with the following handpieces.
KaVo 1:1 shanks KaVo 1:1 heads
INTRAmatic LUX
shank 20 LH
(Mat. no.
0.534.5850)
GENTLEpower LUX
shank 20 LP
(Mat. no.
1.001.7453)
MASTERmatic LUX
shank M20 L
(Mat. no.
1.009.3620)
Note
The INTRA LUX KL 703 LED motor has a torque range from 0.1 Ncm to 2
Ncm. If the torque is in excess of 2.0 Ncm, KaVo recommends using a redu-
cing contra-angle handpiece 3:1 or 8:1 in order to reduce the load on and
heating of the motor.
The reducing contra-angle handpiece should be selected appropriately such
that the torques specified by the file manufacturer are within the recommen-
ded torque range (middle column):
Instructions for use elements e-motion Dental Motor
6 Operation | 6.3 Starting-up the motor
WARNING
INTRA LUX head 68
LU
(Mat. no.
1.003.7191)
INTRA Head L68 B
(Mat. no.
1.008.1834)
31 / 58
KaVo 3:1 heads
INTRA LUX head 66
LU
(Mat. no.
1.004.4587)
INTRA Head L66 B
(Mat. no.
1.008.1831)