Safety Instructions For Maintenance - Husqvarna 1-10DPS75 Bedienungsanweisung

Ammeter
The ammeter shows the blast load onto the surface. The
maximum amperage is shown above the ammeter.
To do a check of the ammeter
Product overview on page 3 for information
Refer to
about where the ammeter is on your product.
1. Start the product. Refer to
page 16 .
2. Wait until the ammeter is in idle position.
3. Stop the product. Refer to
page 19 .
ON/OFF buttons of the blastmotor
The ON/OFF buttons of the blastmotor are used to start
and stop the blastmotor. Refer to
page 3 .
To do a check of the ON/OFF buttons of the blastmotor
Product overview on page 3 for information
Refer to
about where the ON/OFF buttons are on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Start the product. Refer to
page 16 .
3. Push the ON button of the blastmotor.
4. Make sure that the motor starts and the light (A)
comes on.
5. Stop the motor. Refer to
19 .
6. Make sure that the motor stops when you push the
OFF button.
2014 - 002 - 06.04.2023
To start the product on
To stop the product on
Product overview on
To start the product on
A
To stop the product on page
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
To do a check of the ON/OFF switch
Product overview on page 3 for information
Refer to
about where the ON/OFF switch is on your product.
1. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
2. Turn the ON/OFF switch to ON postion.
3. Make sure that the power supply starts.
4. Turn the ON/OFF switch to OFF position.
5. Make sure that the power supply stops.

Safety instructions for maintenance

WARNING:
instructions that follow before you use the
product.
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Clean the product to remove dangerous material
before you do the maintenance.
• Do the maintenance of the product on stable level
ground. Make sure that the product cannot move.
• Do not make modifications to the product.
Modifications that are not approved by the
manufacturer can cause serious injury or death.
• Replace damaged, worn or broken parts.
• Do not use a pressure washer to clean the product.
• Only use lint-free cleaning cloths.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.
Read the warning
9