Husqvarna 1-10DPS75 Bedienungsanweisung Seite 23

disconnected and the blastmotor has fully
stopped.
WARNING:
without the V-belt cover installed.
1. Remove the V-belt cover. Refer to
the V-belt tension on page 22 .
2. Reduce the distance between the blastmotor and the
bearing to release the tension of the V-belt.
3. Remove the old V-belt and install the new V-belt.
4. Increase the distance between the blastmotor and
the bearing to apply tension to the V-belt. Refer to
To do a check of the V-belt tension on page 22 .
5. Attach the V-belt cover.
To do a check of the chain tension of
the drive system
WARNING:
without the chain cover installed.
1. Stop the product. Refer to
page 19 .
2. Remove the chain cover.
2014 - 002 - 06.04.2023
Do not operate the product
To do a check of
Do not operate the product
To stop the product on
3. Push the chain to examine the tension. If you can
push the chain a distance of 5 mm, the tension is
correct.
4. Loosen the nuts.
5. Move the chain wheel to adjust the tension.
6. Tighten the nuts.
7. Install the chain cover.
23