Safety Instructions For Maintenance - Husqvarna 360BT Bedienungsanweisung

• Do not put the product or a fuel container near
warm objects, an open flame, a spark or a pilot
light.
• Always use approved containers for storage and
transportation of fuel.

Safety instructions for maintenance

WARNING:
instructions that follow before you use
the product.
Introduction
WARNING:
the safety chapter before you assemble
the product.
To assemble the blower pipe and the
control handle on the product
1. Attach the flexible hose (A) to the pipe angle and
the control pipe (B) with the clamps (C) and (D).
C
Note:
Lubricate the control pipe and the
flexible hose to make them more easy to
assemble.
2. Attach the handle holder (E) to the control pipe.
Align the handle holder with the flange on the
control pipe.
3. Adjust the position and angle of the control
handle to a safe and correct work position.
Tighten the knob.
1750 - 003 - 03.03.2022
Read the warning
Assembly
Read and understand
A D
B
E
• Stop the engine, remove the spark plug and let
the engine become cool before maintenance and
assembly.
• A blocked spark arrestor screen causes the
engine to become too hot which causes damage
to the engine.
4. Attach the cable to the flexible hose with the
cable clamp.
5. Attach the intermediate pipe to the control pipe.
Note:
If it is a requirement to use a longer
circular blower pipe, an extended intermediate
pipe is available.
6. Attach the blower nozzle to the intermediate
pipe.
Note:
The blower nozzle can only be installed
on the intermediate pipe.
To assemble the handlebar (optional
accessory)
1. Disassemble the intermediate pipe.
2. Remove the knob from the holder and push the
holder onto the control pipe.
63