To Clean The Product - Husqvarna 1-10DPS75 Bedienungsanweisung

General product maintenance
Make sure that nuts and screws
are tight.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Do a check of the RCD.
Examine the electric motor for
dirt and damage.
Make sure that the dust extrac-
tor hose is not damaged and
that there is no blockage.
Empty the dust extractor.
Do a check of the of the abra-
sive separator, the separator
tray and the feedspout.
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush seal
and magnetic seal for wear.
Do a check of the control cage,
blastwheel and liners for wear.
To do before you oper-
Refer to
ate the product on page 10 .
Do a check of the drive belt ten-
sion.
Do a check of the drive chain
tension of the drive system.
Clean the drive chain of the
drive system.
Do a complete servicing and
cleaning of the product.

To clean the product

• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
20
Each 3 h Daily
*
*
*
*
*
*
*
X
X
X
X
X
X
12 h after
service
*
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To clean the chain of the drive system
1. Remove dirt on the outer surface of the chain with a
hard brush or wire brush.
Each 3
Yearly
months
X
X
X
O
2014 - 002 - 06.04.2023