Husqvarna 1-10DPS75 Bedienungsanweisung Seite 16

c) Use drive speed 0–2 on steel surfaces.
To start the product
1. Connect the product to a power supply. Refer to
connect the product to a power source on page 15 .
2. Start the dust extractor. Refer to the operator's
manual of the dust extractor.
3. Attach the dust extractor hose to the product. Refer
To connect a dust extractor on page 14 .
to
4. Turn the emergency stop button clockwise to make
sure that the emergency stop button is disengaged.
5. Set the ON/OFF switch on the electrical enclosure in
the ON position.
6. Engage the drive system. Refer to
drive system on page 10 .
7. Push the ON button to start the blastmotor.
8. Wait until the ammeter is in idle position.
9. Make sure that the direction of rotation of the
blastmotor is correct. Refer to
direction of rotation of the motor on page 15 .
16
To
To engage the
To do a check of the
10. Turn the speed control dial to set the drive speed.
To operate the product
WARNING:
rearward operation only. Do not move the
product forward during operation.
WARNING:
during operation. Abrasive comes out of the
product at high speed and can cause injury.
1. Make sure that the work area is safe. Refer to
area safety on page 7 .
2. Fill the abrasive separator with abrasive. Fill the
separator with abrasive when necessary. Refer to
fill the product with abrasive on page 14 .
3. Start the product. Refer to
page 16 .
4. Engage the drive system. Refer to
drive system on page 10 .
5. Operate the drive system lever.
6. Pull the abrasive control lever to open the abrasive
To operate the abrasive valve on
valve. Refer to
page 12 .
This product is for
Do not lift the blasthousing
Work
To start the product on
To engage the
2014 - 002 - 06.04.2023
To