Husqvarna 1-10DPS75 Bedienungsanweisung Seite 22

5. Remove the blastwheel cover.
6. Put an applicable tool in the blastwheel to prevent
rotation. Remove the bolt and discard it.
7. Remove the blastwheel.
22
8. Install the blastwheel in opposite sequence.
CAUTION:
when you install a new blastwheel.
9. Turn the new blastwheel manually. Make sure that
the blastwheel turns freely and does not hit the
control cage.
To do a check of the V-belt tension
WARNING:
without the V-belt cover installed.
1. Stop the product. Refer to
page 19 .
2. Remove the V-belt cover.
3. Examine the V-belts for damages and wear. Replace
the V-belts if it is necessary.
4. Push the V-belts with your tumb to examine the
tension. If you can push the V-belts a distance of
10–15 mm (A), the tension is correct.
5. If the V-belts tension is not sufficient, increase the
distance between the motor and the bearing.
6. Install the V-belt cover.
To replace the V-belt
WARNING:
belt cover when the power supply is
Always use a new bolt
Do not operate the product
To stop the product on
A
Only remove the V-
2014 - 002 - 06.04.2023