Symbols On The Product - Husqvarna 525PT5S Bedienungsanweisung

13. Throttle trigger lockout
14. Spark plug cap and spark plug
15. Cylinder cover
16. Starter handle
17. Impact guard
18. Fuel tank
19. Air filter cover
20. Air purge
21. Choke control
22. Throttle trigger
23. Throttle/hand guard
24. Operator's manual
25. Harness
26. Transport guard, bar
27. Combination wrench, chain tensioner
28. Combination wrench
29. Hex key

Symbols on the product

WARNING! This product is dangerous.
Injury or death can occur to the operator
or bystanders if the product is not used
carefully and correctly. To prevent injury
to the operator or bystanders, read and
obey all safety instructions in the
operator's manual.
Please read the operator's manual
carefully and make sure that you
understand the instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Note:
Other symbols/decals on the product refer to
certification requirements for other commercial areas.
712 - 007 - 28.04.2021
This product is not electrically insulated. If the product touches or comes close to high-volt-
age power lines it could lead to death or serious injury. Electricity can jump from one point to
another by arcing. The higher the voltage, the greater the distance electricity can jump. Elec-
tricity can also travel through branches and other objects, especially if they are wet. Always
keep a distance of at least 10 m between the machine and high-voltage power lines and/or
any objects that are touching them. If you have to work within this safe distance you should
always contact the relevant power company to make sure the power is switched off before
you start work.
The operator of the product must ensure, while working, that no persons or animals come
closer than 15 meters.
Use heavy-duty slip-resistant boots.
Fuel.
Chain oil.
Adjustment of the oil flow.
Primer bulb.
Choke.
The product agrees with the applicable
EC directives.
The rating plate shows the serial
number. yyyy is the production
yyyywwxxxx
year, ww is the production week
and xxxx is the sequential number.
Direction of rotation, saw
chain.
3