Symbols On The Product; Product Liability - Husqvarna 360BT Bedienungsanweisung

21. Cable clamp
22. Intermediate pipe
23. Blower nozzle
24. Operator's manual
25. Combination wrench
26. Air purge bulb
27. Idle speed screw
28. Handlebar (accessory)

Symbols on the product

WARNING! This product can be
dangerous and cause serious injury or
death to the operator or others. Be
careful and use the product correctly.
Read the operator's manual carefully
and make sure that you understand the
instructions before use.
Use approved hearing protection
and approved eye protection. If the
environment contains dust, use a
breathing mask.
Use approved protective gloves.
Mixture of gasoline and two-stroke oil.
Air purge bulb.
Keep all body parts away from hot
surfaces.
Choke, open position.
Choke, closed position.
This product complies with applicable
EC Directives.
60
Noise emissions to the environment
according to European Directive
2000/14/EC and New South
Wales legislation "Protection of
the Environment Operations (Noise
Control) Regulation 2017". Noise
emission data can be found on the
machine label and in the Technical
data chapter.
yyyywwxxxxx
Note:
Other symbols/decals on the product refer
to certification requirements for other commercial
areas.
Euro V Emissions
WARNING:
engine voids the EU type-approval of
this product.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not
from the manufacturer or not approved by the
manufacturer.
• the product is not repaired at an approved
service center or by an approved authority.
Look out for thrown objects.
Thrown objects can cause
serious injury. Use personal
protective equipment.
Keep a safety distance at a
minimum of 15 m to persons
or animals.
The rating plate shows the
serial number. yyyy is the
production year and ww is
the production week.
Tampering with the
1750 - 003 - 03.03.2022