Märklin digital 60996 Bedienungsanleitung Seite 30

CV
Explanation
1 Main address
2 PoM Minimum speed (Vmin)
3 PoM Acceleration delay (AV)
4 PoM Braking delay (BV)
5 PoM Maximum speed (Vmax)
Automatic Calibration
7
Hersteller Versionsnummer (Softwareversion)
Manufacturer identi cation / ID
8
Decoder reset (default or factory setting)
13 PoM Functions F1 - F8 with an alternative track signal
14 PoM Functions FL, F9 - F15 with an alternative track signal
17 Expanded address, higher value byte
18 Expanded address, lower value byte
19 Multiple unit address
21 PoM
Functions F1 - F8 when using multiple unit
30
CV Table for DCC
Values Default
1 – 127 3
0 – 255 4
0 – 255 3
0 – 255 3
0 – 255 180
– 131
8 –
0 – 255 0
0 – 255 1
192 – 231 192
0 – 255 128
0 – 255 0
0 – 255 0
Notes
Short address 1 - 127
If CV 29 / Bit 5 = 0
Value must be lower than Wert muss Vmax, CV
5. (see CV 67)
CV value multiplied by 0.9 gives the time from
being stopped to maximum speed.
CV value multiplied by 0.9 gives the time from
maximum speed to being stopped.
Speed at the highest speed level.
Value must be higher than Vmin, CV 2.(see also
CV 94)
Enter Value 77. Value 77 is not stored continu-
ously.
0 = Func. MM or analog off
1 = Func. MM or analog on
[ F8 F7 F6 F5 F4 F3 F2 F1 ]
0 = Func. MM or analog off
1 = Func. MM or analog on
[ F15 F14 F13 F12 F11 F10 F9 FL ]
Long address 1 - 10239 (128)
If CV 29 / Bit 5 = 1
1 - 127 = multiple unit address
0 = no multiple unit
+128, Bit 7 = reverse polarity for direction when
using multiple unit
0 = func. # only for locomotive address
1 = func. # also for multiple unit address
Bit 7-0 = [ F8 F7 F6 F5 F4 F3 F2 F1 ]