Märklin digital 60996 Bedienungsanleitung Seite 24

fx (MM) Protocol
Addresses
• 4 addresses (72 / 73 / 253 / 254)
• Address range:
1 – 255 depending on the controller / central controller
• The main address can be programmed manually.
• The consecutive addresses can be turned on, turned off,
set and can be programmed manually or automatically.
Programming
• The characteristics can be programmed for the decoder
can be programmed repeatedly using the programming
for the Con guration Variables (CV). Reading the CVs is
not possible.
• The CV numbers and the CV values are entered directly.
• The default settings (factory settings) can be produced
repeatedly.
• The rst four functions and the lights can always be con-
trolled by means of the rst address; additional functions
can be used, depending on the consecutive addresses.
• All of the settings from the function mapping for mfx or
DCC programming are taken on for fx (Motorola).
24
DCC Protocol
Addresses
• Short address – long address – multiple unit address
• Address range:
1 – 127 for short address and multiple unit address,
1 – 10.239 for long address
• Every address can be programmed manually.
• A short or a long address is selected using the CVs.
• A multiple unit address that is being used deactivates the
standard address.
Programming
• The characteristics can be changed repeatedly using the
Con guration Variables (CV).
• The CV numbers and the CV values are entered directly.
• The CVs can be read and programmed repeatedly. (Pro-
gramming is done on the programming track).
• The CVs can be programmed in any order desired. (Pro-
gramming can be done on the main track PoM). The PoM
can only be done with those designated in the CV table.
Programming on the main track PoM must be supported
by your central controller (Please see the description for
this unit).
• The default settings (factory settings) can be produced
repeatedly.
• 14/28 or 126 speed levels can be set.
• If automatic recognition in braking areas is to be used,
we recommend shutting the DC operation off (see CV
description). In DCC operation setting the value in CV 27
to 16 or 32 (see CV table).