Installer Menu - Dimplex Dhw 301P Montage- Und Gebrauchsanweisungen

English
10.11. Setting a weekly program
The weekly program can be used to set time windows
for different operating modes.
The operating modes are:
"F P": Dehumidify, frost protection mode
"ECO": Optimised heat pump operation
"COnF": Comfort mode with heat pump and
electric additional heating element
In "ECO" mode, use of the supplementary electric
heating is not permitted.
Direct access is by pressing and holding the
ton.
Set day
monday
day
new prog.
Copy of program
from previous day
copy sun.
Copy of standard program
or program from
another weekday
copy prog.
Change existing program
modify Pr.
Open existing program
see PRog.
NOTE
Up to 7 time windows per day are possible, until 24:00
in each case.
NOTE
The heating-up time of the domestic hot water heat
pump depends on the outside temperature. Therefore,
appropriate operating times and modes should be
selected.
Press the button to return to the home screen.
EN-20
but-
Set end of 1st time window
0000-____
00:30
h
Set mode during
1st time window
0630-____
f-p
Set end of 2nd time window
0000-0630
f-p
Confirm
„F-P" Dehumidification and
frost protection function
„ECO" Heat pump operation only
„CONF" Heat pump
+ supplementary electric
heater if required

10.12. Installer menu

Depending on the system configuration, certain pa-
rameters have to be adjusted to optimise the func-
tioning of the domestic hot water heat pump.
Opening the installer menu
Direct access is by pressing the
Turn the dial to open the "INST. MENU" menu.
Simultaneously press and hold the
buttons for three seconds until the display shows
"PV MODE".
pv mode
se tt in g s
reset par.
display
c ou n te rs
Confirm
Press the button to return to the home screen.
FD 0303
button.
and
Activate photovoltaic mode
Activate specific technical
parameters, e.g. thermal
disinfection, speed etc.
Reset to factory settings
Operating status display
Operation counter
www.dimplex.de
Operation