Audio Adjustments; Radio Reception; Auto Tuning - Teac AG-D9100 Bedienungsanleitung

Audio Adjustments

SOURCE DIRECT Source
Indicators
FUNCTION
(Source) Selector
SPEAKERS
POWER
BASS/TREBLE
STANDBY/ON
Tone Controls
Main POWER switch and STANDBY/ON Button
When the main POWER switch is ON:
Press STANDBY/ON button to turn the power on. Press
it again to turn the system off (power standby mode).
The indicator lights up in power standby mode and
goes out when this unit is turned on.
SOURCE DIRECT Button
When this button is pressed, the signal selected by the
FUNCTION (source) selector is supplied directly to the
amplifier circuit, allowing you to listen to the source
with better sound quality. When the SOURCE DIRECT
button is pressed, the BASS, TREBLE controls and SUR-
ROUND mode will be defeated. Press the button again
to release it.
SPEAKER Select Buttons
With the unit in the STEREO mode, SPEAKERS A and B
can be selected simultaneously. If the unit is in any of
the SURROUND MODEs (DOLBY DIGITAL, DOLBY PRO-
LOGIC, DOLBY 3 STEREO, HALL, THEATER, DISCO, or
STADIUM) , speaker selection is automatically limited
to SPEAKERS A only.
BASS/TREBLE Tone Controls
These two tone controls – BASS and TREBLE – can be
used to obtain a "flat" frequency response or a tone
which suits your individual listening preference. The
Bass control adjusts low frequencies and the TREBLE
control adjusts the high frequencies.
BALANCE Control
This control is used to adjust the balance between the
left and right channels. Normally set to the center
position.
LOUDNESS Button
This button compensates for the non-linear response of
the human ear at low volumes. Set this switch to the
OFF position when listening at normal levels.
BALANCE
LOUDNESS
– 11 –

Radio Reception

Auto Tuning

1
POWER ON
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
button.
3. Press the MODE button to change to TUNING mode.
(The PRESET CH. indicator disappears from the
display.)
This button is used to select Tuning or Preset scan
mode.
4. Press the UP or DOWN TUNING button (within 0.5
to 2 seconds). The next station broadcasting at a
frequency higher or lower than that of the current
station is automatically detected and tuned in.
By pressing and holding the TUNING button for
longer than 2 seconds, it will continue to control
(three times faster than normal speed).
FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode.
Stereo
FM stereo broadcasts are received in stereo and
the STEREO indicator lights in the display.
If FM broadcasts with weak signal strength are
received, the FM muting (–20 dB) function works
automatically to cut the signals, eliminating loud
noise.
Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
monaural, reducing unwanted noise.
TUNED Indicator
''TUNED'' appears in the display when a broad-
cast is correctly tuned in.
FM MODE
2
3 4