Philips HomeRun 3000-Serie Bedienungsanleitung Seite 7

English
10
1
2
1
2
Download the app, register, and connect to Wi-Fi
4 Press the home button. The robot drives to the correct position in the station.
5 Wait until the robot is fully charged.
If the battery is empty, the robot will not drive itself to the correct position. In
this case, follow the next steps:
1 Turn the robot to its correct position and put the robot on the floor in front of
the station. The water tank should be facing the station.
2 Align the charging contact points on the water tank of the robot with the
charging contact points on the station.
3 Push the robot against the station so that the charging contacts of the robot
make contact with the charging contacts of the station.
Note: Make sure that the robot is in its correct position and starts to
charge. The lights in the two buttons on top of the robot flash slowly. If the
battery is empty, it may take a while before the robot indicates that it is
charging.
Attention: Even if you charge the robot for the first time, the station will
start vacuuming the robot empty. This is not an error, but is part of the
normal charging procedure.
4 Wait until the robot is fully charged.
Note: Make sure the robot is fully charged before you use it for the first
time.
Note: The white LED on the station also lights up to indicate that the robot is
charging.
App content
You can operate the robot with the Philips HomeRun robot app. The app allows
you to manage your robot and offers help and support:
1 How-to-use videos.
2 Full user manual.
3 FAQs.
4 Contact Consumer Care.
5 Create a map of your home.
6 Select which rooms to clean.
7 Choose between different cleaning modes and settings for each room.
8 View the status of the cleaning run in real time and see the battery level.