Select Function; Setup Function - VOLTCRAFT VC891 Bedienungsanleitung

12.8 SELECT function

Some measurement modes have additional sub-modes. The sub-modes are marked
in grey around the control dial. To switch to a sub-mode, press the "SELECT" button.
Press the button again to switch to the next sub-mode.

12.9 SETUP function

The setup menu serves to configure various system parameters according to your
needs. To select the setup menu, press the "SETUP" button. Use the function but-
tons "F1" and "F2" to navigate through the menu and select menu items.
Use the two arrow buttons "<" and ">" to select the fields you wish to set.
Use the function buttons "F3" and "F4" to change values. Press the "SETUP" button
again to exit the setup menu.
Brightness
Sound
Color Mode
Auto Power Off
Display
Key Light
Torch Time
Cont Threshold
Set Time
Set Date
Date Format
Compare Type
Compare Min
Compare Max
Record Num
Record Rate
Factory Reset
Device Info
Display backlight
Button tones
Display theme (light/dark)
Automatic shut-off (Always ON = disabled)
Display backlight switch-off time
Position illumination on the control dial
Torch switch-off time (Always ON = disabled).
Acoustic continuity test threshold
(1 - 1000 Ω)
System time setting (hours:minutes:seconds)
Date setting
Date Format (DD = day, MM = month, YY = year)
Comparison type (INNER = within tolerance, OUTER =
outside tolerance)
Lower tolerance limit
Upper tolerance limit
Number of stored values (1 - 10000 values)
Storage interval (1 - 10000 s)
Restore factory settings
System information display
81