Operation - Scheppach MS150-42E SE Original Bedienungsanleitung

10. Mowing with grass box:
Lift the discharge flap (15) with one hand and hang
the grass box (16) as shown in fig. 9.
11. Mulching:
If the grass box (16) is attached, remove it and re-
place it with the mulch insert (19) as shown in fig.
10-12.
Setting the cutting height
m CAUTION!
Adjust the cutting height only when the engine is
switched off and the plug boot has been pulled.
• Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are
damaged.
• To prevent any imbalance, replace blunt and/or dam-
aged blades as a set only (if applicable). To carry
out this check, first switch off the engine and pull the
spark plug boot.
• The cutting height is centrally adjusted with the cut-
ting height adjustor lever (fig. 13/ Item 14). 7 different
cutting heights can be selected.
• Pull the adjustor lever out and select the desired
cutting height. The lever snaps into the desired po-
sition. (fig. 13)
Preparing the area to be mowed
Before mowing, carefully examine the area. Remove
stones, sticks, bones, wires, toys and other objects that
may be ejected.
9.

Operation

m ATTENTION!
Always make sure the device is fully assembled
before start-up!
Charge battery pack
Improper use of the battery and charger can result in
an electrical shock or fire.
When charging battery pack
• Charge battery pack only with original battery charger.
• Do not use battery charger to charge any other types
of batteries.
• Keep battery charger dry. Avoid exposing battery
pack to rain or wet conditions.
• To reduce risk of damage to electric plug and cord,
pull by plug rather than cord when disconnecting
charger.
38 | GB
• An extension cord should not be used unless abso-
lutely necessary. Use of improper extension cord
could result in a risk of fire and electric shock. If an
extension cord must be used, make sure:
1. That pins on plug of extension cord are the same
number, size, and shape as those of plug on
charger;
2. That extension cord is properly wired and in
good electrical condition; and
3. That wire size is a minimum of 16 AWG to allow
for AC ampere rating of charger.
• Do not operate charger with damaged plug or cord.
The supply cord cannot be replaced. If the cord is dam-
aged, the charger should be replaced immediately.
• Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. If charger is damaged it must be replaced.
Charger is not serviceable.
• Do not disassemble charger; or attempt to service.
• To reduce risk of electric shock, unplug charger from
outlet before cleaning.
• Do not short circuit; never place any object into the
battery contacts.
• The charger is not intended for use by persons (in-
cluding children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowl-
edge, unless they have been given supervision or
instruction concerning use of the appliance by a per-
son responsible for their safety.
• Children should be supervised to ensure that they
do not play with the charger.
When to charge battery pack
As Required - To check available charge, press the
Battery Fuel Gauge button (E, Fig. 25) and charge if
required. See the Battery Fuel Gauge section.
How to charge battery pack
1. Connect battery charger to electrical outlet. Keep
battery charger dry. Avoid exposing battery pack to
rain or wet conditions.
2. (Fig.26)Slide the battery firmly into the battery
charging bay. Make sure the battery pack is firmly
seated in the battery charging bay.
3. A completely discharged battery pack will fully
charge in approximately three (3) hours. The battery
pack will stay fully charged if left on the charger.
4. To check available charge, press the Battery Fuel
Gauge button (E, Fig. 25) .
5. When not in use, disconnect battery charger from
electrical outlet.
www.scheppach.com