Configuring The Product - Sygonix 2588866 Bedienungsanleitung

14.4 Configuring the product

The camera must be turned on. The status LED (A) must flash red.
For configuration via Wi-Fi, ensure your smartphone and the Wi-Fi camera are
connected to the same network.
Important: Please note that only 2.4 GHz Wi-Fi networks are supported. The
Wi-Fi signal must be stable at the place of installation, especially outdoors.
If the Wi-Fi signal is weak, make sure you use a Wi-Fi repeater to improve
signal quality.
You can add a new device manually by tapping "+" (A14) on the top right of the
app's main page and selecting the device you want to add. Otherwise, tap the
blue button (A4) below in the middle.
Scan the QR code on the camera
to add the camera in the app.
To scan the QR code, tap the but-
ton in the top right corner of the
screen (arrow in the screenshot).
Use your smartphone to scan the
QR code attached to the side of
the camera.
When the smartphone reads the
QR code, the camera beeps, and
a pop-up window appears to add
the camera.
Tap the blue button to confirm.
56