Installation And Handover Protocol; Installation Site - ATH Four Lift 55HAP Bedienungsanleitung

8.1

Installation and handover protocol

Installation site:

Company:
Street:
City:
Country:
The product listed above has been assembled, checked for function and safety, and put into operation. The
installation was carried out by:
The operator
The operator confirms the proper installation of the product type, to have read and understood all information
of this operating manual and protocol and to observe them accordingly, as well as to keep these documents
accessible to the instructed operators at any time.
The operator confirms that after installation and commissioning by a trained person of the manufacturer or
an authorized dealer (expert), he has been instructed in the function, handling, safety-relevant specifications,
maintenance and care of the machine, has received the documents, information and specifications of the
machine and that the product functions properly.
IMPORTANT NOTE:
SHOULD THE ABOVE POINTS NOT BE FULFILLED, THE WARRANTY CLAIM WILL EXPIRE!
The warranty is only valid in case of compliance with and proof of proper installation, handover, if necessary
instruction of the machine as well as the annual maintenance by an expert authorized by the manufacturer. The
interval between 2 maintenance intervals must not exceed 12 months. In the case of non-standard use or multi-
shift or seasonal use, a ½ yearly inspection and maintenance must be agreed.
Warranty claims will only be accepted if all points in the protocol and in the operating instructions have been
fulfilled, the claim is made immediately after discovery and this protocol is sent to the manufacturer in
connection with the maintenance and, if applicable, service protocol.
Furthermore, the specific information on the warranty (scope, claims and specifications) as described in the
operating instructions must be observed.
Damage and claims resulting from improper handling, failure to provide maintenance and care, use of unsuitable
or not specified assembly, operating, maintenance and care materials, mechanical damage, tampering with the
equipment without consultation or by unauthorized experts are excluded from the warranty. For systems that
have not been installed by an authorized expert, the warranty is limited by agreement of the manufacturer to a
maximum of the provision of the necessary spare parts.
Name and company stamp of the expert
if necessary number and name VKH
Name and company stamp of the operator
® Copyright ATH-Heinl GmbH & Co. KG / All rights reserved / Misprints and technical changes reserved
Release date: 16.03.2023 / Product manufacturer ATH-Heinl GmbH & Co. KG
Device/installation:
Manufacturer:
Type/Model:
Serial Number:
Year of manufacture:
The expert
Date and signature of the expert
Date and signature of the operator
129